Follow

How do I change the WiFi network?

If you wish to change the WiFi network for your smartfrog camera, you will need to restore the camera to the factory settings. Please proceed with the following steps: 
• Make sure the camera is plugged in to a power outlet
• On the back of the camera, locate the small hole next to "reset" 
• Please insert a paperclip or pin into reset hole for 10 seconds or until you hear a beep.  The LED status light should turn solid red.

Your camera is now reset to factory settings.  You can now install the camera on a different WiFi network. Please use the same WiFi network on your smartphone for installation.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments