Follow

How do I change the Wi-Fi network?

If you wish to change the Wi-Fi network for your Smartfrog Camera, you will need to restore the camera to the factory settings. Please proceed using the following steps: 
• Make sure the camera is plugged in to a power outlet
• On the back of the camera, locate the small hole next to "reset" 
• Please insert a paperclip or pin into reset hole for 10 seconds or until you hear a beep.  The LED status light should turn solid red.

Your camera is now reset to factory settings.  You can now install the camera on a different Wi-Fi network. Please use the same Wi-Fi network on your smartphone for installation.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments